+- studentsuvidha (https://studentsuvidha.com/forum)
+-- Forum: Projects, Presentations and Seminars (https://studentsuvidha.com/forum/Forum-Projects-Presentations-and-Seminars)
+--- Forum: Mechanical engg projects (https://studentsuvidha.com/forum/Forum-Mechanical-engg-projects)
+--- Thread: Fuel injection in diesel engines project (/Thread-Fuel-injection-in-diesel-engines-project)
Fuel injection in diesel engines project - admin - 02-04-2014
Mechanical and electronic injectionOlder engines make use of a mechanical fuel pump and valve assembly which is driven by the engine crankshaft, usually via the timing belt or chain. These engines use simple injectors which are basically very precise spring-loaded valves which will open and close at a specific fuel pressure. The pump assembly consists of a pump which pressurizes the fuel, and a disc-shaped valve which rotates at half crankshaft speed. The valve has a single aperture to the pressurized fuel on one side, and one aperture for each injector on the other. As the engine turns the valve discs will line up and deliver a burst of pressurized fuel to the injector at the cylinder about to enter its power stroke. The injector valve is forced open by the fuel pressure and the diesel is injected until the valve rotates out of alignment and the fuel pressure to that injector is cut off. Engine speed is controlled by a third disc, which rotates only a few degrees and is controlled by the throttle lever. This disc alters the width of the aperture through which the fuel passes, and therefore how long the injectors are held open before the fuel supply is cut, controlling the amount of fuel injected.This contrasts with the more modern method of having a separate fuel pump (or set of pumps) which supplies fuel constantly at high pressure to each injector. Each injector then has a solenoid which is operated by an electronic control unit, which enables more accurate control of injector opening times depending on other control conditions such as engine speed and loading, resulting in better engine performance and fuel economy. This design is also mechanically simpler than the combined pump and valve design, making it generally more reliable, and less noisy, than its mechanical counterpart.Both mechanical and electronic injection systems can be used in either direct or indirect injection configurations.